Appendix; Daily Care And Maintenance; Functions Using The Switch Panel On The Egx-20 - Roland EGX-20 User Manual

7 Appendix

Daily Care and Maintenance

 Use a vacuum cleaner to carefully clean away cutting dust.
 Use a toothbrush or the like to remove cuttings from the adhesive sheet.
 Do not use an air blower or the like to blow away cutting dust. The cuttings may get inside the machine and cause
breakdown.
 Use a dry or well wrung-out cloth to wipe clean. Do not use solvents such as thinner or alcohol.
 Lubrication is not required. Improper application of grease or the like may actually lead to breakdown and should not
be attempted.

Functions Using the Switch Panel on the EGX-20

In addition to the usual operations using the switch panel, you can also use the switch panel to carry out operations like the
ones described below.
Carry out the following operations with the power to the EGX-20 switched off and the EGX-20 disconnected from the AC
adapter.
Displaying the Working Time of the Spindle Motor
During normal operation, if the Z-axis light flashes slowly for ten seconds (four or five flashes) when you turn on the power,
it means the spindle motor has been powered up for over 1,000 hours.
The spindle motor is a consumable part. As a general guide, we recommend replacing it after every 1,000 hours.
You can also use the following procedure to check the number of hours that the spindle motor has been powered.
1. While holding down the View button on the switch panel, insert the AC adapter into the EGX-20.
The illumination and flashing of the Z-axis light, Power light, View light, and Origin Set light show how many hours the unit
has been powered up.
2. After you have verified the time, press the View button. This switched off the power.
Z-axis light
Power light
View light
Origin Set light
Resetting the Working Time of the Spindle Motor
When you have replaced the spindle motor with a new motor, follow the steps below.
 While holding down the power and View buttons on the switch panel, insert the AC adapter into the EGX-20.
The View light illuminates and the powered time of the spindle motor is reset.
Setting the Origin Point to Its Default Value (the Lower Left Corner)
 While holding down the Origin Set button on the switch panel, insert the AC adapter into the EGX-20.
The Origin Set light illuminates and the origin point is set to its default (at the lower left corner).
Setting the Origin Point at the Center of the Table
 While holding down the center of the movement button on the switch panel, insert the AC adapter into the EGX-20.
The Z-axis light illuminates and the origin point is set at the center of the table.
44 7 Appendix
Less than 250 Less than 500
hours hours
 
– –
– –
–

Less than 750 Less than 1,000
hours hours
 
–

 
 
 : Illuminated – : Dark
1,000 hours or
more
 Slow flashing



 : Flashing