Powering On - Roland CAMM PRO PC-60 User Manual

2 Powering On

Do not allow hands or hair to come
near the platen while the carriage is
in motion.
Failure to do so may result in injury due to
sudden movement of the carriage when the
power is switched on, when the sheet
loading lever is raised or lowered,
or when the
CUT TEST
key is
pressed.
1
When using the unit for the first time, switch on
the main power switch on the left-hand side of the
unit. (At this time, all LEDs flash once. )
Press the side of the
switch marked " –".
Leave the main power
switch on, and use the
sub power switch for
switching the unit on
and off on an everyday
basis.
2
Make sure the sheet loading levers are raised, then
press the key (the sub power switch) on the
control panel.
2 Powering On
The POWER LED
lights up
19