U8: Custom Monitors For Driveworksez; Control Mode Dependent Parameter Default Values; Dependent Parameters And Default Values - YASKAWA V1000 Series Installation & Start-Up Manual

No. Name
Offset
U6-21
Frequency
U8-01 –
U8-02 –
U8-03 –
U8-04 –
U8-05 –
U8-06 –
U8-07 –
U8-08 –
U8-09 –
U8-10 –
<60> Available for the drive software version 1011 or later.
<27> Setting units for this parameter are determined by o2-04, Drive/kVA Selection. Less than 11 kW: 2 decimal
points, 11 kW and above: 1 decimal point.
◆

Control Mode Dependent Parameter Default Values

The tables below list up parameters that depend on the control mode selection (A1-02 for
motor 1, E3-01 for motor 2). These parameters are initialized to the shown values if the
control mode is changed.
Table B.1 A1-02 (Motor 1 Control Mode) Dependent Parameters and Default Values
Para-
Description
meter
b3-02 Speed Search deactivation current
YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual
Description
Displays the frequency added to the main
frequency reference.

U8: Custom Monitors for DriveWorksEZ

U8 parameters are reserved for DriveWorksEZ
Reserved for DriveWorksEZ, Monitor 1.
Reserved for DriveWorksEZ, Monitor 2.
Reserved for DriveWorksEZ, Monitor 3.
Reserved for DriveWorksEZ, Monitor 4.
Reserved for DriveWorksEZ, Monitor 5.
Reserved for DriveWorksEZ, Monitor 6.
Reserved for DriveWorksEZ, Monitor 7.
Reserved for DriveWorksEZ, Monitor 8.
Reserved for DriveWorksEZ, Monitor 9.
Reserved for DriveWorksEZ, Monitor 10.
Setting Range Resolution
0 to 200
B.2 Parameter Table
Control
Mode
Analog
Output Unit
V/
Level
f
10 V: max. 0.1
A A A 7D5
frequency %
0.01
Α A Α 1950
–
%
0.01
– A A A 1951
%
0.01
– A A A 1952
%
0.01
– A A A 1953
%
0.01
– A A A 1954
%
0.01
– A A A 1955
%
0.01
– A A A 1956
%
0.01
– A A A 1957
%
0.01
– A A A 1958
%
0.01
– A A A 1959
%
Control Modes (A1-02)
V/f (0) OLV (2)
1 % 120 100
Addr.
O
P
Hex
L
M
V
B
PM (5)
–
383