Lexmark CX331 User Manual page 62

Use printer menus
Menu item
Toner patch sensor setup
Full calibration
Toner patch sensor setup
Print TPS information page
Scanner Configuration
Scanner Manual Registration
Print Quick Test
Scanner Configuration
Scanner Manual Registration
Front ADF Registration
Flatbed Registration
Scanner Configuration
Edge Erase
Flatbed Edge Erase
0–6 (3*)
ADF Edge Erase
0–6 (3*)
Scanner Configuration
Disable Scanner
Enabled*
Disabled
ADF Disabled
Scanner Configuration
Tiff Byte Order
CPU Endianness*
Little Endian
Big Endian
Scanner Configuration
Exact Tiff Rows Per Strip
On*
Off
Note: An asterisk (*) next to a value indicates the factory default setting.
Out of Service Erase
Menu item
Sanitize all information on nonvolatile memory
Erase all printer and network settings
Erase all shortcuts and shortcut settings
Description
Run the full color calibration.
Print a diagnostic page that contains toner patch sensor
calibration.
Print a Quick Test target page.
Note: Make sure that the margin spacing on the target page
is uniform all the way around the target. If it is not, then the
printer margins may need to be reset.
Manually register the flatbed and ADF after replacing the ADF,
scanner glass, or controller board.
Set the size, in millimeters, of the no‑print area around an ADF
or flatbed scan job.
Disable the scanner when it is not working properly.
Set the byte order of a TIFF‑formatted scan output.
Set the RowsPerStrip tag value of a TIFF‑formatted scan output.
Description
Clear all settings and applications that are stored in the printer.
62