Invacare TDX SP2 Series Service Manual page 40

Invacare® TDX® SP2 Series
• 5 mm Allen key
• Oblong wooden
block (at
least 14 x 14 x 30
cm)
• 5 mm Allen key
• 13 mm wrench
• Oblong wooden
block (at
least 14 x 14 x 30
cm)
Removing Wheel
1. Place wooden block underneath mobility device and
prop up mobility device.
2. Remove end-caps from bolt and nut (if applicable).
3.
Remove nut from bolt A.
4. Remove bolt and wheel from fork.
Installing Wheel
1. Install parts in reverse order.
2. When installing wheel, pay attention to correct
direction of rotation.
3. Tighten nut to prescribed torque. See 6.8.4 Specific
Tightening Torques, page 35.
Replacing Castor Wheel (Storm
• 5 mm Allen key (up
to August 2016)
• TX40 Torx key
(starting August
2016)
• Oblong wooden
block (at
least 14 x 14 x 30
cm)
40
Fig. 6-24
4 Max)
Removing Wheel
1. Loosen and remove bolts A.
2.
Pull wheel C including axle D and bushing B out of
fork E.
Installing Wheel
CAUTION!
Risk of injury from wheels coming loose
If wheels are insufficiently secured during
mounting, it can come loose when driving.
– When mounting wheels tighten bolts with
prescribed torque.
– Secure all bolts using a suitable blocker.
– Never use normal nuts instead of self-locking
nuts.
– Always use new nuts and bolts with an
undamaged coating.
1. Install parts in reverse order. Pay attention to correct
direction of rotation when installing wheels.
2. Test all functions.
Replacing Castor Wheel (TDX SP2)
• 2x 7/16" wrench
• Oblong wooden
block (at
least 14 x 14 x 30
cm)
Removing Wheel
Fig. 6-26
1. Loosen nut (2).
2. Remove screw (6).
3. Remove two washers (3) and (5).
Fig. 6-25
1532486-N