Component
Chair configuration
Screws (every 6
months)
6.5 Overview mobility device
This overview applies for TDX SP2 mobility devices with
Modulite Seat.
Underneath seat
Batteries behind front shroud A
Power module behind rear shroud A
Actuator modules
Tilt actuator (optional) A
Actuator module (optional) B
Lifter actuator (optional) C
1532486-N
Check
Remedy
Check chair
Update software
configuration version
if newer version
available
Check screws for tight
Tighten screws if
fit
necessary
Fig. 6-1
Fig. 6-2
Fig. 6-3
Notes
See LiNX service manual.
Lifter
ACT with Lifter
located under the seat.
Center mount powered legrests and tilt module
G-Trac® Sensor
The optional G-Trac-sensor is located behind the rear
shroud.
Service
21