Siemens SINUMERIK 840D sl Turning Operating Manual page 670

Multi-channel machining
11.2 Multi-channel support
Parameter
Spindle chuck
data
Spindle chuck
data
ZC
ZS
ZE
Counter-spindle
Spindle chuck data
Spindle chuck data
Jaw type
ZC
ZS
ZE
XR
ZR
Mirroring Z
670
Description
● Yes
You enter spindle chuck data in the program.
● No
Spindle chuck data is transferred from the setting data.
Note:
Please observe the information provided by the machine manufacturer.
● Only chuck
You enter spindle chuck data in the program.
● Complete
You enter tailstock data in the program.
Note:
Please observe the information provided by the machine manufacturer.
● The main spindle chuck dimensions - (only for spindle chuck data "yes")
● Stop dimension of the main spindle - (only for spindle chuck data "yes")
● Jaw dimension of the main spindle for jaw type 2 - (only for spindle chuck data
"yes")
● Yes
You enter spindle chuck data in the program.
● No
Spindle chuck data is transferred from the setting data.
Note:
Please observe the information provided by the machine manufacturer.
● Only chuck
You enter spindle chuck data in the program.
● Complete
You enter tailstock data in the program.
Note:
● Please observe the information provided by machine manufacturer.
Selecting the jaw type of the counter-spindle. Dimensions of the front edge or stop
edge - (only if spindle chuck data "yes")
● Jaw type 1
● Jaw type 2
The counter-spindle chuck dimensions - (only for spindle chuck data "yes")
Stop dimension of the counter-spindle - (only for spindle chuck data "yes")
Jaw dimension of the counter-spindle for jaw type 2 - (only for spindle chuck data
"yes")
Tailstock diameter - (only for spindle chuck data "complete" and tailstock that has
been set up)
Tailstock length - (only for spindle chuck data "complete" and tailstock that has been
set up)
● Yes
Mirroring is used when machining on the Z axis
● No
Mirroring is not used when machining on the Z axis
Operating Manual, 06/2019, A5E44903486B AB
Unit
mm
mm
mm
mm
mm
mm
mm
mm
Turning