Reinstall Components; Step 4: Connect External Devices And Dpc Cables; Connect To A Network For Out-Of-Band Management - Juniper MX960 Quick Start Manual

Reinstall Components

1.
2.
NOTE: Make sure that all empty slots are covered with a blank panel before operating
the router.

Step 4: Connect External Devices and DPC Cables

To connect external devices and DPC cables, perform the following procedures:
Figure 7: Connect External Devices and DPC Cables

Connect to a Network for Out-of-Band Management

1.
2.
Slide each component into the chassis evenly so that it does not become stuck
or damaged.
Tighten the captive screws for each component.
Connect to a Network for Out-of-Band Management on page 13
Connect a Management Console on page 14
Connect the DPC Cables on page 14
Turn off the power to the management device.
Plug one end of the RJ-45 Ethernet cable into the
Engine.
Step 4: Connect External Devices and DPC Cables
ETHERNET
Step 4: Connect External Devices and DPC Cables
port on the Routing
13