Juniper MX960 Quick Start Manual page 9

Ethernet services router

Hide thumbs Also See for MX960:

Table of Contents

Figure 4: Load the Router onto the Lift

Using the lift, position the router in front of the rack or cabinet, centering it in

front of the mounting shelves.

Lift the chassis approximately 0.75 in. above the surface of the mounting shelves

and position it as close as possible to the shelves.

Carefully slide the router onto the mounting shelves so that the bottom of the

chassis and the mounting shelves overlap by approximately two inches.

Slide the router onto the mounting shelves until the mounting brackets or

front-mounting flanges contact the rack rails. The shelves ensure that the holes

in the mounting brackets and the front-mounting flanges of the chassis align

with the holes in the rack rails.

Move the lift away from the rack.

To install the router in an open-frame rack, install a mounting screw into each

of the open mounting holes aligned with the rack, starting from the bottom.

Visually inspect the alignment of the router. If the router is installed properly in

the rack, all the mounting screws on one side of the rack should be aligned with

the mounting screws on the opposite side and the router should be level.

Step 3: Install the Router

Table of Contents