Epson STYLUS SCAN 2500 Manual page 120

Caution:
c
❏ EPSON recommends the use of genuine EPSON ink
❏ Never remove a cartridge from the Stylus Scan until you
❏ If you are using the Automatic Document Feeder and need
Note:
❏ Once a cartridge becomes empty, you must replace it before
continuing printing or performing a maintenance operation. The
Stylus Scan cannot operate if either cartridge is empty.
❏ In addition to the ink used during document printing, ink is
consumed during the print head cleaning operation and during the
self cleaning cycle which is performed when the Stylus Scan is
turned on.
Before replacing ink cartridges, make sure the Stylus Scan is on.
The operate light should be on and not flashing. Determine which
ink cartridge needs to replaced by referring to the LCD Panel on
the control panel.
1. Make sure the Stylus Scan is on. The Operate light should be
on.
2. Refer to the panel message to determine which cartridge is
low or empty.
3. Open the document cover and maintenance cover.
116
cartridges. Products from other manufacturers may cause
damage not covered under the EPSON warranty.
have a new cartridge on hand to replace it. Leaving the Stylus
Scan with a missing cartridge may cause ink in the print
head nozzles to dry out.
to replace the ink cartridge, remove the Automatic Document
Feeder from the Stylus Scan, but do not pull out the
connector.