Epson STYLUS SCAN 2500 Manual page 12

Using the parallel port (for Windows 98 and 95)
To connect the Stylus Scan to your PC using the parallel port, you
need a shielded, twisted-pair parallel cable. Follow the steps
below to connect your Stylus Scan to your PC via the parallel port.
1. Make sure both the Stylus Scan and computer are turned off.
2. Plug the cable connector securely into the parallel interface
connector at the rear of the Stylus Scan. Squeeze the wire clips
together until they lock in place on both sides. If there is a
ground wire at the end of the cable, connect it to the ground
connector at the back of the Stylus Scan.
3. Plug the other end of the cable into the computer's parallel
interface.
You are now ready to install the Stylus Scan drivers. For
installation instructions, see "For Windows 98 or 95 with a parallel
connection" on page 10.
Using the USB port (for Windows 98 and Macintosh)
To connect the Stylus Scan to your computer using the USB port,
you must first install the Stylus Scan drivers.
8