Dometic Frigo DC Operating Manual page 7

Frigo DC
2
Fig. 2: Overview of control unit, display
The display indicates the system status:
No. in
fig. 2
1
2
3
4
5
5.2 Switching on the refrigeration system
A
NOTICE!
Only operate the electrical refrigeration system with a running engine or
plugged in power cable (supplementary equipment "Stationary Cooling") to
prevent the vehicle's battery from running down!
I
NOTE
If the ambient temperature is lower than the set value, the set temperature will
not be achieved as the refrigeration system does not have a heating function.
Below 0 °C the refrigeration systemrefrigeration system switches off due to the
low internal pressure, to prevent the compressor from being damaged.
➤ Switch on the ignition.
➤ Start the motor.
➤ Wait until your vehicle's loading monitor lamp has gone out.
EN
P
Symbol Description
Temperature
Compressor
Defrosting
Evaporator fan
Alarm
1
Function description
Current temperature in the
Lights up if the compressor is on
Flashes if the activation of the com-
pressor is delayed
Lights up in defrosting mode
Flashes during the drip period
Lights up if the fan is on
Flashes if the activation of the fan is
delayed
Lights up if there is an error message
(chapter "Faults" on page 18)
Operation
2
3
4
5
cargo space
7