Installing Shoe Clips (Cleats) - Schwinn IC4 Assembly Manual / Owner's Manual

Installing the Shoe Clips (Cleats) on Cycling Shoes
Note: The provided shoe Cleats fit both the right and left Pedals.
Tools needed: pliers, 4mm hex wrench
1. With a pair of pliers, pull off the rubber cover to expose
the cleat mounting holes on the bottom of the cycling
shoe.
Note: This step may not be necessary, depending on the
type of shoe.
2. Remove the sockliner and put the Cleat Nut in position
over the oval holes inside the shoe.
Note: This step may not be necessary, depending on the
type of shoe.
3. From the bottom of the shoe, put a Cleat in position over
the cleat holes and then a Cleat Adapter. Be sure the
single arrow on the Cleat points toward the toe, or front,
of the shoe. Tighten the cleat mounting bolts (2.5 N·m).
4. The Cleat has an adjustment range of 20mm (0.8") front
to back and 5mm (0.2") left to right. Practice engaging
with the Pedal and releasing, one shoe at a time.
Readjust to determine the best Cleat position.
5. Using a 4mm hex wrench, fully tighten the cleat
mounting bolts (5 – 6 N·m).
(Cycling Shoes not provided)
4 mm
13