Disconnect After Silence Of Or Continuous Signal Of Xs; Automatic Pause Prior To Dialling - Aiphone JKTLI Operation Manual

3.5.2 Disconnect after silence of or continuous signal of X seconds – Function 97
Default setting = 2.
JKTLI will hang up if:
- No voice or DTMF is detected for X seconds,
- There is a continuous tone for X seconds.
* 2000 # (3 short beeps) 97 (long beep) Y (3 short beeps)
With Y=
- 0: function is OFF
- 1: time is 5 seconds
- 2: time is 10 seconds
- ....
- 9: time is 45 seconds.
Example: if the tone signalling the end of the communication is continuous, and if time
programmed is 10 seconds, during the communication, if JKTLI detects a continuous tone during
10 seconds, it will cut the line.
3.5.3 Automatic pause prior to dialling – Function 98
Default setting = 3.
JKTLI can be programmed to pause from 1 – 6 seconds before dialling.
A pause can also be included in the phone number (ie if JKTLI is installed on an extension port of a
Pabx).
* 2000 # (3 short beeps) 98 (long beep) X (3 short beeps)
With X = time in seconds, from 1 to 6 seconds.
AIPHONE
21
31.08.11 – V1.0