3.4 Special Programming
After doing the basic programming (§3.2), it is possible to adapt JKTLI to special requirements
by entering the following parameters.
3.4.1 Communication ends after activation of JK-1MED relay – Function 35
Default setting = 1-0.
* 2000 # (3 short beeps) 35 (long beep) 0 (3 short beeps) = NO
* 2000 # (3 short beeps) 35 (long beep) 1 (long beep) 0 (3 short beeps) = Communication ends
immediately after activation of JK-1MED relay (default)
* 2000 # (3 short beeps) 35 (long beep) 1 (long beep) 1 (3 short beeps) = Communication ends
5s after activation of JK-1MED relay (default)
3.4.2 Communication ends after activation of JKTLI relay – Function 37
Default setting = 1-0.
* 2000 # (3 short beeps) 37 (long beep) 0 (3 short beeps) = NO
* 2000 # (3 short beeps) 37 (long beep) 1 (long beep) 0 (3 short beeps) = Communication ends
immediately after activation of JKTLI relay (default)
* 2000 # (3 short beeps) 37 (long beep) 1 (long beep) 1 (3 short beeps) = Communication ends
5s after activation of JKTLI relay (default)
3.4.3 Call Notification when the Telephone is busy
Default setting = 1 = Voice message.
JKTLI can be programmed to notify that there is a call from the panel when the telephone is busy.
* 2000 # (3 short beeps) 43 (long beep) 0 (3 short beeps) = Notification via beep.
* 2000 # (3 short beeps) 43 (long beep) 1 (3 short beeps) = Notification via message "Call from
Door Panel" or "Telephone Call".
3.4.4 Type of ringing signal on internal phone – Function 58
Default setting = option call ring 0.
* 2000 # (3 short beeps) 58 (long beep) 0 (3 short beeps) = Ring 1.5 seconds, silence 3.5 seconds
repeated.
* 2000 # (3 short beeps) 58 (long beep) 1 (3 short beeps) = Ring 1 second, silence 1 second
repeated.
3.4.5 Ringing time before answering (for JKTLI) – Function 59
Default setting = 020.
If JKTLI is installed on the same telephone line than a handset, it could be interesting to delay answer
from JKTLI when receiving a call.
* 2000 # (3 short beeps) 59 (long beep) YYY (3 short beeps)
With YYY = time in seconds.
Minimum: 010 for 10 seconds
Maximum: 255 for 255 seconds.
3.4.6 Changing Programming Password
Parameters Programming Password
Default setting = 2000.
* 2000 # (3 short beeps) 90 (long beep) PPPP (3 short beeps)
With PPPP: new password (4 digits required).
Call-Button Programming Password
Default setting = 2001.
* 2001 # (3 short beeps) 91 (long beep) PPPP (3 short beeps)
With PPPP: new password (4 digits required).
WARNING! The two passwords must be different.
AIPHONE
– Function 43
18
31.08.11 – V1.0