Hose - Graco EcoQuip 300 Operation, Repair, And Parts

Operation
Connecting the the Blast Blast Hose
Connecting Connecting the Blast

Hose

Hose Hose
1. EQ30XS EQ30XS and EQ30XS and and EQ60XS EQ60XS EQ60XS only:
grounding cable to the external ground stud (ZH)
on the enclosure, then connect the clamp to a
true earth ground.
2. Always purge the air supply hose 15–20 seconds
before connecting the air supply hose from the
compressor (or on-site compressed air source)
to the panel. Make sure all debris is cleared from
the hose.
12
Hose and and Air Air
Hose and Air
only: Connect the only:
3. Connect an appropriately sized air
supply hose to the air inlet. See
Technical Specifications, page
NOTE: NOTE: Make sure to properly install hose NOTE:
restraints and coupler pins to the quick-coupler
and the air line. If the holes on the quick-coupler
do not align, there is something wrong and the
two couplers are not compatible. DO
ON THE THE AIR AIR. Seek help to get the situation
ON ON THE AIR
resolved.
49.
DO NOT NOT TURN TURN
DO NOT TURN
334667G