IBM System/36 Maintenance Information Manual page 59

Example Error History Table
ERROR HISTORY TABLE FOR XXXXXXXX
FROM: XX/XX/XX XX:XX:XX TO: XX/XX/XX XX: XX: XX
DATE TIME SRC (Information used to generate SRCs)
YY/MM/DD HH:MM:SS .................. HEX ...................... .
XX/XX/XX XX:XX:XX XXXX XXXX XXXX XXXX
xxxx
XX/XX/XX XX:XX:XX XXXX XXXX XXXX XXXX XXXX
XX/XXjXX
XX: XX: XX XXXX XXXX XXXX XXXX XXXX
XX/XX/XX XX:XX:XX XXXX XXXX XXXX XXXX XXXX
Notes:
XXXX
XXXX
XXXX
XXXX
xxxx
XXXX
XXXX
XXXX
1.
When you display ERAP reports for some devices, not all of the information available in the reports is
shown. However, the additional information is available when you print or spool the reports (see the
procedure "Spool and Display ERAP Reports").
2. See the manual Program Problem Diagnosis and Diagnostic Aids, SY21-0593, to interpret special fields
associated with communications SRCs.
Spool and Display ERAP Reports
The local work station attachment and disk error history tables contain additional information that is not
displayed. When a printer is busy, or is not available, you can send the ERAP report to the system spool
writer. The spooled output can be displayed at a local work station using the following procedures.
To Spool the ERAP Output
1. From the ERAP Main menu, select the option for disk or local work station.
2. Select a disk drive or the local work station attachment.
3. Select the option to print the report.
4. Enter the ID of the printer to receive the output and the additional output option (S) to spool the
output.
Note: The printer ID must be valid but the printer does not need to be operational.
5. Enter the desired time range.
Note: If the selected printer is not operational, a message is sent to the system console indicating that the
printer and the system are not communicating. If this occurs, use option 1 to respond to the
message.
6. End ERAP and return to the Main (help) menu.
Section 3. General Procedures
3-25