IBM System/36 Maintenance Information Manual page 130

1010 Tape Drive Removal
1. Power off the 5363 and disconnect the power cord at the customer power outlet and the 5363.
2. Remove the covers ("305 Cover Removal" on page 3-2).
3. Remove the four mounting screws (two on each side) from the tape drive.
4. Slide the tape drive slightly towards you to permit access to the cables.
5. Disconnect PII power cable and the signal cable.
6. Remove the tape drive by sliding the unit towards you until it is out of the 5363 frame.
7. Install the tape drive by doing the previous steps in reverse order.
P11 (Power Cable)
R36B133-2
10-2
5363 Maintenance Information