IBM System/36 Maintenance Information Manual page 53

12. Slide the Al board logic gate assembly towards you out of the 5363 frame.
13. Place the logic gate on a firm surface with the 12 screws securing the Al board facing up.
Note:
Note the location of the BI-G connectors, this will be of help to you when you reinstall the Al
board. If this note is not followed you may reinstall the Al board backwards.
14. Remove the 12 screws securing the Al board to the logic gate assembly.
15. Do not remove the plastic insulator under the Al board. No more disassembly is required.
Section 3. General Procedures
3-19