IBM System/36 Maintenance Information Manual page 57

To End the Alter/Display Option
There are two methods of ending the alter/display options. (For options 10 and 12, use only method 1.)
Method 1: Using the Cmd7 Key
On all displays except the Alter/Display Options menu, you can use the Cmd7 key to end the alter/display
option. For the Alter/Display Options menu, see the procedure ("To End the Alter/Display Function").
Method 2: Using the E Parameter
All alter/display options (except options 10 and 12) display an end (E) parameter. Key an E in the parameter
field and press the Enter key; the Alter/Display Options menu is displayed.
Note: On storage displays, change the storage indicator (M, R, X, or C) on the first storage address to an E.
To End the Alter/Display Function
There are two methods of ending the alter/display function. Use method 1 when you can display the
Alter/Display Options menu. Use method 2 when you cannot use method 1.
Method 1: Using the Alter/Display Menu
1. Select option 0 (Exit Alter/Display) from the Alter/Display Options menu.
2. Press the Field Exit key.
Method 2: Using the Control Panel
1. If the Output Display light is off, press the Display key. A 1 is displayed in the low-order position of the
4-character display; the three high-order positions are blank.
2. Change the 1 to a 0 using the low-order Input key.
3. Press the Start Function key.
Note: For more information about using the alter/display utility, see the manual Program Problem Diagnosis
and Diagnostic Aids, SY21-9684.
Section 3. General Procedures
3-23