ISSUE 1.0
When you want to ...
Change Program Number
Change Index Number
Move Cursor to Right
S
6 PROGRAMMING NAMES AND TEXT MESSAGES
ECTION
Several programs (e.g., Program 20-16 : Selectable Display Messages) require you to enter text. Use
the following chart when entering and editing text. When using the keypad digits, press the key once
for the first character, twice for the second character, etc. For example, to enter a C, press the key 2
three times. Press the key six times to display the lower case letter. The name can be up to 12 digits
long.
Use this keypad digit ...
1
2
3
4
5
6
7
8
9
0
*
#
Clear/Back or DND/CONF (4W
Hybrid Multiline Terminal) / DND
(IP Multiline Terminal)
Flash
S
7 USING SOFTKEYS FOR PROGRAMMING
ECTION
(This Feature is available for IP Multiline Terminal Only.)
Each Display telephone with Softkeys provides interactive Softkeys for intuitive feature access. The
options for these keys will automatically change depending on where you are in the system
programming. Simply press the Softkey located below the option you wish and the display will change
accordingly.
Networking Manual
Soft Key3
Cursor Key (Right)
Soft Key4
Table 5-3 Keys for Entering Names
Enter characters : 1 @ [ ¥ ] ^ _ ` { | }
Enter characters : A-C, a-c, 2.
Enter characters : D-F, d-f, 3.
Enter characters : G-I, g-i, 4.
Enter characters : J-L, j-l, 5.
Enter characters : M-O, m-o, 6.
Enter characters : P-S, p-s, 7.
Enter characters : T-V, t-v, 8.
Enter characters : W-Z, w-z, 9.
Enter characters : 0 ! " # $ % & ' ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters :
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
*
# = Accepts an entry (only required if two letters on the same key are needed - ex : TOM).
Pressing # again = Space. (In system programming mode, use the right arrow Softkey in-
stead to accept and/or add a space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the right.
Telephone Programming
When you want to ...
Á À Â Ã Å Æ Ç É Ê ì ó 0
SL2100
5-5