Setting For The Speaker (Speaker Settings Menu) - Sony STR-DN1000 Operating Instructions Manual

Setting for the speaker
(Speaker Settings menu)
You can adjust each speaker manually.
You can also adjust the speaker levels after the
Auto Calibration is completed.
Note
The speaker settings are only for the current seating
position.
Speaker Settings menu
parameter
x SP Pattern (Speaker pattern)
Select "SP Pattern" according to the speaker
system which you are using. You do not need
to select the speaker pattern after Auto
Calibration.
To select the speaker pattern
1
Press V/v repeatedly to select
"SP Pattern", then press
The "SP Pattern" screen appears.
2
Press V/v repeatedly to select the
speaker pattern you want, then press
.
3
Press RETURN/EXIT O.
x SB Assign (Surround back
speaker assign)
You can make settings for the surround back
speaker(s). Before you change "SB Assign" to
"BI-AMP" or "Speaker B", be sure you have
set "SP Pattern" to a setting without surround
back speakers.
• Speaker B
If you connect an additional front speaker
system to the SPEAKERS SURROUND
BACK/FRONT B/BI-AMP terminals, select
"Speaker B" (page 38).
• BI-AMP
If you connect front speakers in a bi-
amplifier configuration, select "BI-AMP"
(page 113).
• OFF
If you have not connected surround back
speakers, select "OFF".
Note
Set "SB Assign" to "OFF", then connect the
surround back speakers to this receiver when you
want to change the connection from a bi-amplifier
connection or front speakers B connection to a
surround back speakers connection. Re-set up the
speakers after you connect the surround back
or b.
speakers. See "9: Calibrating the appropriate
speaker settings automatically (Auto Calibration)"
(page 40).
x Manual Setup (Manual setup)
You can adjust each speaker manually on the
"Manual Setup" screen. You can also adjust
the speaker levels after the Auto Calibration is
completed.
To adjust the speaker level
You can adjust each speaker's level (front left/
right, center, surround left/right, surround
back left/right, subwoofer).
1
Press V/v/B/b repeatedly to select the
speaker on the screen for which you
want to adjust the level, then press
2
Press B/b repeatedly to select "Lvl:".
3
Press V/v repeatedly to set the level of
the selected speaker, then press
.
.
continued
73 US