Saving/Loading Settings Of The Receiver; Setting The In-Ceiling Speaker Mode - Sony STR-AZ7000ES Startup Manual

• Error 38:
It wasn't possible to measure correctly. Move the speaker
or microphone position a little and try again. If noisy,
measure with as little surrounding noise as possible.
• Warning 40:
Measurement complete, but it is noisy. It may be possible
to measure again, but it is not possible to measure in all
environments. Measure with as little surrounding noise as
possible.
• Warning 41, Warning 42:
The input from the measurement microphone is excessive.
The speaker and microphone may be too close. Place the
speaker and microphone away from each other. If using
this unit as a preamplifier, this message may be displayed
depending on the connected power amplifier, but it can be
used as it is.
• Warning 43:
The subwoofer distance and phase could not be measured.
Noise may be the cause. Re-measure in a quiet
surrounding environment.
• Warning 44:
Measurement finished, but the center speaker positional
relationship may be unsuitable. Check the speaker position
referring to "Installing speakers" in the Help Guide.
* The speaker name in this warning message depends on the
detected symptom.
• NO WARNING:
There is no warning information.

Saving/loading settings of the receiver

You can save the settings to a USB flash drive and restore
the saved settings to the receiver or to another receiver of
the same model.
Saving Loading
To save the settings
Insert a USB flash drive to the USB port on the front panel of
the receiver.
Select [Setup] - [Install Settings] - [Save/Load] - [Save] from
the home menu.
To load the settings
Insert to the USB port on the front panel of the receiver a
USB flash drive on which the settings are saved.
Select [Setup] - [Install Settings] - [Save/Load] - [Load] from
the home menu.
38
EN

Setting the in-ceiling speaker mode

This feature will virtually relocate the front and center
in-ceiling speakers down to around the screen. That way, the
customer will hear the actors' voices coming from the screen
instead of the ceiling. This mode also makes music sound
more natural in a room with in-ceiling speakers.
1
Perform Auto Calibration.
2
Select [Sound Effects] -
[In-Ceiling Speaker Mode] - [Front & Center] or
[Front] from the home menu.
Notes
• This mode is not available when [Pure Direct] is set to [On].
• This mode will be disabled in a speaker pattern with Dolby Atmos
enabled speakers.
Tips
• You can select on/off for each input on the Input Settings screen.
• To obtain optimal effects in the listening environment, set
[Manual Speaker Settings] - [Height] - [Ceiling] from the
[Speaker Settings] menu and perform Auto Calibration.