JVC DT-U31 Instructions Manual page 17

*2 UMD control
Select UMD mode to "External" will enable TSL UMD control.
TallyMan system connection:
RS485 IN
RS485 OUT
They are female terminals.
Pin No RS 485 IN
1 GPI 1
2 GPI 2
3 GPI 3
4 GPI 4
5 GPI 5
6 GPI 6
7 NC
8 GND
Serial connections:
TallyMan
RS-485 IN RS-485 RS-485
OUT
RS 485 OUT
GPI 1
GPI 2
GPI 3
GPI 4
GPI 5
GPI 6
NC
GND
RS-485 RS-485 RS-485
IN OUT IN OUT
*3 Webserver IP Control
Connect the monitor ETHERNET port into LAN, and the monitor can
be remote controlled by webpage.
ETHERNET
Enter Menu- External Control - IP/Net Mask/Gateway/Port to
set the monitor addresses.
Set the computer Ethernet IP address at the same LAN
environment as the Monitor.
2) Launch any of a web browser on the computer, and enter URL:
Monitor IP + port (for example 192.168.1.99:8080). The webserver
control page will be displayed.
Monitor IP address
Use crossed wired cable for computer-monitor directly
connection.
Use straight-through wired cable for Router connection.
Please seek help from your webmaster for any network
connections.
Pin No Pin name
1 TX+
2 TX-
3 RX+
4
5
6 RX-
7
8
Monitor port address
17