JVC DT-U31 Instructions Manual page 16

External Control
Setting for TALLY, UMD, IP control to the monitor
Item
Tally Setting
Tally Position
GPI Control
1 Pin
2 Pin
3 Pin
GPI *1
4 Pin
5 Pin
6 Pin
Back
Exit
UMD *2
UMD Mode
UMD Position
UMD Size
UMD Color
UMD Blending
Source ID
TSL Address
TSL Baud Rate
TSL Data Bits
TSL Parity
TSL Stop Bits
IP *3
Net Mask
Gateway
Port(1024~65535)
Back
Exit
*1 GPI control
Connect GPI remote controller with "GPI" port of the monitor
rear panel,
Switch on the "GPI Control".
Assign functions for GPI 1-6.
Control the GPI 1-6 pin terminals to short-circuit with the GND
pin terminal, to enable the assigned function, and disconnect-
ing (opening) to disable the functions.
GPI
16
To do
Set on-screen tally display mode
Select the display position of on-screen tally
Enable GPI control
Assign functions to the GPI terminals
Return to previous menu
Exit Main Menu
Switch on the UMD display
Select the UMD source
Select the display position of UMD
Select UMD display size
Select UMD display color
Select UMD background transparency
Edit internal UMD letters
TSL UMD setting
Set monitor IP address for webserver
remote control
Return to previous menu
Exit Main Menu
Pin No Pin name
1 GPI 1
2 GPI 2
3 GPI 3
4 GPI 4
5 GPI 5
6 GPI 6
7 NC
8 GND
Setting value
OFF, ON, Blinking
Top, Bottom
OFF, ON
SFP, SDI1,SDI2, SDI3, SDI4, 4xSDI(2SI), 4xSDI(SQ),
HDMI, Red Tally, Green Tally, Yellow Tally, Time code,
Color Temp, Flip mode, Freeze Frame,
WFM Single Line, UMD, Marker, H/V Delay,
Audio bar, Zebra, Vector, Low Latency Mode, Histogram
Odd/Even Frame, Lissajous, Focus Assist, False color
OFF, ON
Internal, External
Top, Bottom
Large, Small
White, Red, Green, Blue, Black, Gray
OFF, Low, HIGH
A-Z, a-z, 0-9, Space, &()*+,-./:<>_
1~126
115200
8
None
1
192.168.001.200
255.255.255.000
192.168.001.001
08080
The GPI controlled TALLY signal will display both front TALLY
light and on-screen TALLY:
TALLY light
On screen TALLY
Green/Red/Yellow
Green
On screen TALLY
Red