Running; Riding - Honda CBR 250R Manual

Ignition Cut Off
Your vehicle is designed to automatically
stop the engine and fuel pump if the vehicle
is over-turned (a banking sensor cuts off
the ignition system). Before restarting the
engine, you must turn the ignition switch to
the OFF position and then back to ON.
RUNNING-IN
Help assure your vehicle's future reliability
and performance by paying extra attention
to how you ride during the first 500 km
(300 miles).
During this period, avoid full-throttle starts
and rapid acceleration.

RIDING

Review Vehicle Safety (page 3-7) before
you ride.
Make sure the side stand is fully retracted
before riding the vehicle. If the stand is
extended, it may interfere with control
during a left turn.
Make sure flammable materials such as dry
grass or leaves do not come in contact with
the exhaust system when riding, idling, or
parking your vehicle.
40
CBR 250R
1. After the engine has been warmed up,
the vehicle is ready for riding.
2. While the engine is idling, pull in the
clutch lever and depress the gearshift
pedal to shift into 1st (low) gear.
3. Slowly release the clutch lever and at
the same time gradually increase engine
speed by opening
Co-ordination of the throttle and clutch
lever will assure a smooth positive start.
4. When the vehicle attains a moderate
speed, close the throttle, pull in the
clutch lever and shift to 2nd gear by
raising the gearshift pedal.
This sequence is repeated to progressively
shift to 3rd, 4th, 5th and 6th (top) gear.
Honda Motorcycle & Scooter India Pvt. Ltd.
the throttle.