Running-In; Riding - Honda CB125 Shine SP Owner's Manual

Flooded Engine
If the engine fails to start after repeated
attempts, it may be flooded with excess
fuel.
(Use the start button)
To clear a flooded engine, turn the ignition
switch to ON, and move the choke knob to
fully OFF (B). Open the throttle fully and
crank the engine for 5 seconds. If the engine
starts, quickly close the throttle, then open
it slightly if idling is unstable. If the engine
does not start, Wait for 10 seconds, then
follow the starting procedure.
(Use the kickstarter)
To clear a flooded engine, turn OFF the
ignition switch and move the choke knob
to fully OFF (B). Open the throttle fully
and crank the engine several times with
the kickstarter. Turn the ignition switch to
ON and open the throttle slightly; start the
engine using the kickstarter.
Honda Motorcycle & Scooter India Pvt. Ltd.

RUNNING-IN

Help assure your vehicle's future reliability
and performance by paying extra attention
to how you ride during the first 500 km
(300 miles).
During this period, avoid full-throttle starts
and rapid acceleration.

RIDING

Review Vehicle Safety (page 3-7) before
you ride.
Make sure the side stand is fully retracted
before riding the vehicle. If the stand is
extended, it may interfere with control
during a left turn.
1. After the engine has been warmed up,
the vehicle is ready for riding.
2. While the engine is idling, pull in the
clutch lever and depress the gearshift
pedal to shift into 1st (low) gear.
3. Slowly release the clutch lever and
at the same time gradually increase
engine speed by opening the throttle.
35
CB125 Shine SP