Honda CBR 250R Manual page 57

Changing the oil filter requires a torque
wrench. If you do not have it and the
necessary skill, we recommend that you have
your Honda dealer perform this service.
If a torque wrench is not used for this
installation, visit your nearest
as soon as possible to verify proper assembly.
Change the engine oil with the engine at
normal operating temperature and the
vehicle on its side stand to assure complete
and rapid draining.
1. Place a drain pan under the crankcase.
2. To drain the oil, remove the oil filler cap, "Oil
Drain Bolt" (1) and "Sealing Washer"
(1)
(1) Oil Drain Bolt
(2) Sealing Washer
Honda Motorcycle & Scooter India Pvt. Ltd.
3. Remove the right under cowl (page 36).
4. Remove the "Oil Filter Cover" (3),
Honda dealer 5. Install the new oil filter with the ''OUT-
(2).
(2)
(7)
(3) Oil Filter Cover
(4) Gasket
(5) Spring
(6) Oil Filter
(7) Oil Filter Cover Bolt
(8) ''OUT-SIDE'' Mark
"Gasket" (4) "Spring" (5) and "Oil Filter"
(6), by removing the "Oil Filter Cover
Bolt" (7).
SIDE Mark" (8) facing out.
(3)
(6)
(5) (8)
(4)
51
CBR 250R