Installing Firmware (Main Firmware); Checking Firmware Version - Brother HL-L5000D Service Manual

7.1 Installing Firmware (Main Firmware)

7.1.1 Checking firmware version

Check whether the firmwares installed on the MX, TT, and LT are the latest version. If they
are the latest version, there is no need to install the firmware. If they are not, be sure to install
the firmware to the machine as described in
<How to check firmware version>
Non touch panel models
(1) Press the [▲] or [▼] key in the initial
state of maintenance mode to display
"MAINTENANCE 25" on the LCD, and
press the [OK] key. "MAIN:Ver*.** (#)"
is displayed on the LCD.
(2) Pressing the [Go], [▲] or [▼] key
changes the display item as shown in
the table on page "5-13".
(3) Press the [X] key, and the machine
returns to the initial state of
maintenance mode.
Memo:
• You can also check the Main firmware version by implementing "Print maintenance
information (function code: 77)" (refer to
(function code: 77)" in Chapter
"7.1.2 Installing
Touch panel models
(1) Press the [2], and then the [5] key in
the initial state of maintenance mode.
"MAIN:Ver*.** (#)" is displayed on the
LCD.
(2) Pressing the [▲] or [Mono] key
changes the display to the next item.
(3) When you press the [X] key, this
operation is finished and the machine
returns to the initial state of
maintenance mode.
"1.3.18 Print maintenance information
5).
4-16
firmware".
Confidential