Print Frame Pattern (Duplex Printing) (Function Code: 70) - Brother HL-L5000D Service Manual

1.3.15 Print frame pattern (duplex printing) (function code: 70)

<Function>
This function is used to print the frame pattern on both sides of the paper to check for printing
flaws and omission.
<Operating Procedure>
Non touch panel models
(1) Set the paper specified in the default paper
settings (A4 or Letter) to the paper tray.
(2) Press the [▲] or [▼] key in the initial
state of maintenance mode to display
"MAINTENANCE 70" on the LCD, and
press the [OK] key. "PRINTING" is
displayed on the LCD, and the frame
pattern (refer to the figure below) is
printed on both sides of the paper.
(3) When printing is completed, "WAKU
DX" is displayed on the LCD. Press the
[X] key, and the machine returns to the
initial state of maintenance mode.
Note:
• If printing fails, printing is stopped with displaying any of the errors shown in the table below. To
retry printing, refer to the "Remedy" in the table below and eliminate the error cause. "PRINTING"
is displayed on the LCD, and the frame pattern is printed on both sides of a sheet of paper.
Error display
Replace Toner
Cover is Open
No Paper
Jam Tray1
Jam Rear
Jam 2-sided
2-sided Disabled

Frame pattern
Replace the toner cartridge to release the error.
Close the front cover.
Refill the paper and close the paper tray to release the error.
Remove the jammed paper, and then close the paper tray and all
covers to release the error.
Remove the jammed paper, and then close all covers to release
the error.
Remove the jammed paper, and then close the duplex tray and all
covers to release the error.
Refill the paper, and then close the paper tray and all covers to
release the error.
(First side)
Fig. 5-15
5-34
Touch panel models
(1) Set the paper specified in the default paper
settings (A4 or Letter) to the paper tray.
(2) Press the [7], and then the [0] key in
the initial state of maintenance mode.
"PRINTING" is displayed on the LCD,
and the frame pattern (refer to the
figure below) is printed on both sides
of the paper.
(3) When printing is completed, "WAKU
DX" is displayed on the LCD. When
you press the [X] key, this operation is
finished and the machine returns to
the initial state of maintenance mode.
Remedy
(Second side)
Confidential