Firmware Confirmation After The Pc Board/Hdd Replacement; Set Line Adjustment Mode - Toshiba e-STUDIO 5540C Service Manual

(11) Perform "Automatic gamma adjustment" <PPC> (05-7869).
 P. 6-31"6.2.1 Automatic gamma adjustment"
(12) Perform "Automatic gamma adjustment" <PRT> (600dpi: 05-8008, 1200dpi: 05-8009).
 P. 6-49"6.3.1 Automatic gamma adjustment"
Remarks:
Usually, it is only necessary to perform automatic gamma adjustment for [Plain paper]; however if
other paper is used, perform automatic gamma adjustment per paper type.
[D] Set line adjustment mode
(1) Turn the power OFF.
(2) Start up with the Setting Mode (08).
(3) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(4) Set "Line adjustment mode" to "0: For factory shipment" (08-9010).
Notes:
Be sure to change the setting of "Line adjustment mode" (08-9010) to "0: For factory shipment".
Since "1: For line" is set for "Line adjustment mode" in SRAM supplied as a service part, number
of prints is not counted unless it is changed.
9.2.8

Firmware confirmation after the PC board/HDD replacement

After replacing the PC board/HDD, check the firmware version in the setting mode (08) and confirm if
the firmware combination is correct.
Firmware
Updating Master data
(HDD program data)
Updating System ROM
(OS data)
Updating PFC ROM
(PFC firmware)
Updating Engine ROM
(Engine firmware)
Updating Scanner ROM
(Scanner firmware)
Updating RADF ROM
(RADF firmware)
Updating Finisher ROM
Updating FAX ROM
* If "NGD" is displayed for the PFC ROM.version (08-9940), the downloading of PFC ROM fails.
Update the firmware again.
 P. 11-52"11.6 When Firmware Updating Fails"
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
Code
08-8952 HD data external version
08-9900 System software version
08-9930 System ROM version
08-9940 PFC ROM version
08-9901 Engine ROM version
08-9902 Scanner ROM version
08-9903 RADF ROM version
08-9904 Finisher ROM version
Saddle stitcher ROM version
08-9944 Hole punch unit ROM version
08-9945 Converter ROM version
08-9905 FAX ROM version
9 - 47
Remarks
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
REPLACEMENT OF PC BOARDS/HDD
9