Wolf BWL-1S-05 Installation And Operating Instructions Manual page 70

Contractor Description
parameter
WP058 Enable function for active cooling.
WP061 Sets night mode end time (WP061 must be less than WP062)
WP062 Sets night mode start time (WP061 must be less than WP062)
WP064 Limits maximum possible compressor frequency and fan speed during night mode.
WP066 Night mode
Used to enable/disable limitation of the maximum possible fan speed and compressor frequency
values within the set duration of night mode.
Enabling night mode results in a reduction of the maximum potential heating output/cooling capacity
of the appliance.
WP080 Dual mode point for deactivation of the compressor.
WP090 Enables the electric heater for heating mode.
WP091 Dual mode point for activation of the electric heater for heating mode
WP092 For setting power-OFF for the electric heater.
WP093 Deactivation of the dual mode point (WP091) of the electric heater for the set period. Used during
the screed drying function to ensure that the electric heater supports the heat pump.
WP094 Sets existing electric heater or
currently installed connected load of electric heater.
WP101 Dual mode point for activation of additional heat generator for heating mode.
WP104 Additional heat generator activation via eBUS.
WP121 Serves to limit the compressor start-ups per hour.
70
Contractor parameters
3064298_201805