Standard Settings; Description; Active Cooling; Dhw Quick Heat-Up - Wolf BWL-1S-05 Installation And Operating Instructions Manual

25.4 Standard settings
In the "Standard settings" submenu of the BM-2, the following standard system settings can be configured.
Designation
Heating appliance
Heating circuit, mixer 1, ...
Language
Time
Date
Winter/summertime
Min. backlighting
Screensaver
Key lock
User interface

25.5 Description

(Selection and more details in the BM-2 programming unit installation instructions.)
25.5.1 Active cooling
Enables the user to activate/deactivate active cooling.
This requires, amongst other things, that the system is configured with active cooling and that active cooling is
enabled via contractor parameter WP058 (factory setting: OFF).
(See chapter "Additional functions".)
25.5.2 DHW quick heat-up
If the DHW quick heat-up standard setting is on, the DHW temperature is regulated once to the set DHW temperature
configured on the AM/BM-2, using all available heat generators. The standard setting is then automatically reset.
25.5.3 DHW operating mode
Comfort setting:
In the Comfort setting, the heat pump tries to reach the set DHW temperature.
After the delay period (WP013/WP023) has elapsed, the electric heater/additional heat generator is activated.
58
BM-2 programming unit

Active cooling

Night mode → BM FW2.30 →
contractor parameter WP066

DHW quick heat-up

DHW operating mode

Economy factor
Winter-summer changeover
ECO ABS
Day temperature
Room influence
Day temperature, cooling
Setting range
OFF, ON
OFF, ON
OFF, ON
ECO, Comfort
0.0 ... 10.0
0.0 ... 40.0 °C
-10.0 ... 40.0 °C
5.0 °C ... (day temperature
cooling - 2 K)
OFF, ON
(Day temp. + 2K) ... 35.0 °C
English, etc.
00:00 ... 23:59
01/01/2000 ... 31/12/2099
Auto, manual
0 ... 15 %
OFF, ON
OFF, ON
Extended, simplified
Factory setting
ON
ON
OFF
ECO
4.0
20.0 °C
10.0 °C
20.0 °C
OFF
24.0 °C
German
Auto
10 %
ON
OFF
Extended
3064298_201805