Appendix I: Information Prompt And Solutions - JUKI PS-800 Instruction Manual

Appendix I: Information Prompt and Solutions

1. "Pressure box didn't put down"
Cause: The press frame was not dropped before resetting, processing, file capture and file
modification
Solution: Click
2. "These is no reset"
Solution: Click
3. "X-axis drive open circuit"
Cause: a. X-axis motor is not connected
b. Loose motor interface
Solution: Turn off the power and check the motor line for connection anomaly.
4. "The bottom thread has been used up"
Cause: The bottom thread required by pre-processed file is longer than the remaining bottom
thread (total length of processing statistics interface - initial length of bottom thread)
Solution: a. Use the bottom thread statistics function to replace the bottom thread and modify
relevant length information;
b. Where the bottom thread statistics function is not used, you can click
disable it. See Section 2.2.5 and "User Settings".
5. "The quantity of work is full"
Cause: In the processing statistics interface, the "current value of count by piece" increases to
the "total count by piece"
Solution: a. If the processing statistics function is used, it's necessary to modify the "current value
of count by piece" or the "total count by piece" so that the former is less than the latter.
b. Where the processing statistics function is not used, you can click
it directly. See Section 2.2.5 and "User Settings".
6. "File range out of bounds"
Cause: a. The length and width of the processing file are beyond the processing range
b. The length and width of the processing file is within the processing range, but the
to drop the frame.
.
84
to
to disable