Reinforcement Preset - JUKI PS-800 Instruction Manual

4.12 Reinforcement Preset

If current file capture segment requires start & end or overlap reinforcement sewing, press
key to enter reinforcement setup interface as shown in the figure below. Upon completion
of setup, the
require no reinforcement, you can click
reinforcement modes available, i.e. backstitch, shrinkage suture, and lambdoidal suture.
Backstitch: Perform overhanding near the start point or end point of sewing curve for
reinforcement. Set the backstitch count and stitch count as needed. If the set value is 0, no backstitch
will be performed. Upon completion of the setup, press
key must be depressed to put the settings into force. If the subsequent graphs
or set the value to 0, and press
Reinforcement mode selection: There are three
key to save current settings.
30
.