Display Instruction For Manual Frame Movement Interface - JUKI PS-800 Instruction Manual

:To reduce or enlarge the current graphics as a whole, the width and length are the
actual width and length of the reduced or enlarged graphics.
: For the beginning or end of each line segment of the current figure, the change
depends on the stitch length of needles increases or decreases.It meanis to increase if the value is
greater than 0, and vice versa.
: Modify the length of the stitching needle of the current figure. Reserved
Commands means that retain some functional code instructions inserted by users after modifying the
length of needle spacing
: Press the key to get into the suspension position interface that is used to set the
positions (up to 6) of suspension during sewing operation.
: "Previous interface" key,Press the key to go back to the main interface of processing.
: "Manual frame movement" key,Press the key to get into the manual frame movement
operation interface.
Thread winding: Press touch key "Start" at the bottom of the screen in this interface, and
confirm, when the spindle motor will rotate for thread winding at the set speed, while
appears at original position of
operation can also be stopped by pressing "Start" and "Emergency stop" buttons. The speed can be
regulated through

2.2.3 Display Instruction for Manual Frame Movement Interface

Click on
manual frame movement interface. In the manual frame movement interface, it's possible to move
the frame manually and control the rotation of each shaft.
; click this key to stop winding operation. The winding
during winding operation.
and successively in the main interface of processing to get into the
10
key