Test Interface Display Description - JUKI PS-800 Instruction Manual

:"Manual press frame up/down" key, Press the key to switch between lifting and pressing
of press frame.
:"Manual press foot up/down" key, Press the key to switch between lifting and pressing
of press foot.
:"Press foot thread clamp" setup key, Set press foot height or thread clamp strength. Note:
This function is not available unless the press foot type is set to motorized press foot in parameter
software.
:"Next interface" key, Press the key to get into test interface.

2.2.2 Test Interface Display Description

Bottom thread winding and other manual operations can be performed in the processing assist
interface.
Key functions in the assist interface are described as follows:
: Auto hook change. If the machine is designed with "auto hook change" feature, signal
will be output for rotating hook change when the key is depressed.
:"Bottom thread winding on/off" key: Press the key to switch between "allow" and
"prohibit". Activate "Allow" and press the "Start" switch to start the winding operation, when the
spindle will wind the thread at the speed set in this page. The winding will stop if the start switch or
is depressed again or the set winding time elapses. "Prohibit" means thread winding is
8