Control Mode - Delta HES Series User Manual

01 Motor Parameters

Control mode

VF
Control mode
Settings
This parameter determines the control mode of this AC motor.
0: V/F control, the user can design the required V/F ratio. It is used for induction motors.
1: Reserved
2: Reserved
3: FOC vector control + Encoder. It is used for induction motors.
4: Reserved
5: FOC vector control + Encoder. It is used for synchronous motors.
6: Reserved
Source of operation command
Control mode VF
Settings
For the operation command, press the PU button to allow the "PU" indicator to be lit. In this
case, the RUN, JOG, and STOP button are enabled.
Motor's maximum operation frequency
Control mode VF
Settings
Set the maximum operation frequency range of the motor. This setting is corresponding to the
maximum flow for the system.
Motor's rated frequency
VF
Control mode
Settings
Typically, this setting is configured according to the rated voltage and frequency listed in the
specifications on the motor's nameplate. If the motor is intended for 60Hz, set this value as
60Hz; if the motor is intended for 50Hz, set this value as 50Hz.
The motor's rated frequency will be different as Rated speed of the synchronous motor
(Pr.01-19) and Number of poles of the synchronous motor (Pr.01-20) change.
Motor's rated voltage
VF
Control mode
Settings
Typically, this setting is configured according to the rated operation voltage shown on the
motor's nameplate. If the motor is intended for 220V, set this value as 220.0V; if the motor is
intended for 200V, set this value as 200.0V.
FOCPG FOCPM
0：V/F
1: Reserved
2: Reserved
3: FOCPG
4: Reserved
5: FOCPM
6: Reserved
FOCPG FOCPM
0: The operation command is controlled by the digital operation panel
1: The operation command is controlled by the external terminals. The
STOP button on the keypad panel is disabled
2: The operation command is controlled by the communication interface.
The STOP button on the keypad panel is disabled
FOCPG FOCPM
50.00~600.00Hz
FOCPG FOCPM
0.00~600.00Hz
FOCPG
230V series: 0.1~255.0V
460V series: 0.1~510.0V
Chapter 4 Parameter Functions
the parameter can be set during operation
4-21
|HES Series
Factory default: 5
Factory default: 1
Factory default: 166.67
Factory default: 113.33
Factory default: 220.0/440.0