Rinnai Linear Series Operation Manual page 9

Flame and heat setting
Once the fire is turned on the
flame setting defaults to level five
(on high). Use the up and down
buttons to control the height of the
flame and heat output.
The relationship between the flame
height and fan speed is preset and
cannot be adjusted. The fire has
five flame and fan settings:
Flame height Fan speed
1 low
2 low
3 low
4 high
5 high
Black retaining bridge
Safety device that needs to be
removed before replacing the
batteries—DO NOT DISCARD, this
MUST BE put back on.
Pry point for removing the back
cover
Gently pry open the back cover
from the base of the remote
Turning on and off
This button switches the fire on and
off. For it to work the power button
on the fire must be ON.
Indicative room temperature
display
Displays the room temperature* (at
the point of the remote) and low
battery symbol if the batteries need
changing.
The back light will stay on for
approximately five seconds.
Constant activation will shorten
battery life.
* Checks the room temperature every
minute.
N.B: Do not compare the temperature
readings from the remote and the app. The
readings are being taken from different
places and could vary significantly.
Battery retainer
Temperature sensor position
The temperature sensor is located
in the bottom of the remote. Please
be aware the sensor will be affected
by direct sunlight, draughts, and
body temperature (your hand).
Linear operation guide: 13562-B 02-19 | 9