Installation
2.6
PROFIBUS address assignment
Properties
Specify the PROFIBUS address under which the ET 200eco I/O station is
accessed on PROFIBUS DP.
Requirements
• The PROFIBUS-DP address for ET 200eco is set at the terminal block.
• All PROFIBUS-DP addresses must be unique.
• The set PROFIBUS address must match the PROFIBUS address specified in
your configuration software (for this ET 200eco).
• A change of PROFIBUS–DP address is only valid after the ET 200eco has
been powered up (power ON).
Tools required
• 14 mm socket wrench
• Screwdriver with 2.5 mm blade
2-6
ET 200eco Distributed I/O Station
A5E00158716-02