AT&T Merlin 206 Manual page 20

1.
Check Voice Terminal ports
Plug a Voice Terminal (using a 34 Button Display Set is required) into ports to be used for "Telephone
Emulation" (TE).
When doing this check, use the Telephone Emulation Cable that will be connected to the Classic Mail
to verify that the cord is good. If the telephone does not work, replace the cord and repeat this check.
Verify that the ports are good. If the intercom light goes on and you get intercom dial tone when you lift
the handset the port is good.
Verify that the ports have access to all necessary C.O. lines by touching the button, if the red and green
lights come on you have access, if the lights remain dark there is no access to this line
If all ports are good and have access to all of the necessary lines proceed with installation.
If the necessary lines are not appearing proceed to the next step.
2.
Enter Administration Mode
Plug a Voice Terminal into port #10.
Slide the "Test/Program" (T/P) switch on the left side of the Voice Terminal to the P position, enter into
"System Administration" by pressing Administer on the Voice Terminal or dialing #49. Do not lift the
handset or enable the speaker-phone.
3. Program Intercom Lines
Dial an intercom number used for Telephone Emulation port (the intercom number corresponds with the
port number i.e. port 10 = intercom 10, port 11= intercom 11 etc.) If all lines to be answered by the Classic
Mail are green dial the next TE intercom number.
If any lines that are to be answered or that require access are not lit green, touch the line button and the
light should turn green.
Dial the next TE intercom number or the intercom number of the phone requiring access, and repeat the
previous steps.
Upon completion of programming return the T/P stitch on the Voice Terminal to the center position.
Classic Mail Installation Package - Page 20
Merlin Plus Release 2
820 D2