AT&T Merlin 206 Manual page 15

1. Check Voice Terminal Functionality
Plug a Merlin Voice Terminal (using a 34 Button Display Set is required) into each port to be used for "Telephone
Emulation" (TE).
When doing this check, use the Telephone Emulation Cable that will be connected to the Classic Mail to
verify that the cord is good. If the telephone does not work, replace the cord and repeat this check.
Verify that each port is operational. If you can make and receive a call the voice terminal port is good.
Verify that each port has access to all necessary C.O. lines by touching each line button, if the red and green
lights come on you have access, if the lights remain dark there is no access to this line.
If all ports are good and have access to all of the necessary lines proceed with installation.
If the necessary lines do not appear proceed to the next step.
2.
Enter Administration Mode
Plug a Merlin Voice Terminal into port #10 (or port 0 on the 206), place the "Admin" switch in the "Admin"
position, (on the 820 it is located on the front upper left of the KSU, on the 410, switch #10 must be in the
down position, on the 206, switch #0 must be in the down position).
Slide the "Test/Program" (T/P) switch on the left side of the Voice Terminal to the P position enter into
"System Administration" by pressing Administer on the Voice Terminal or dialing #01. Do not lift the
handset or enable the speaker-phone.
3. Program Intercom Lines
Dial the intercom number of TE port (the intercom number corresponds with the port number i.e. port 10 =
intercom 10, port 11= intercom 11 etc. On the 206, port 0 = intercom 0 etc.) If all lines to be answered by the
Classic Mail are green dial the next TE intercom number.
If any lines that are to be answered or that require access are not lit green, touch the the button and the light
should turn green.
Remove call restrictions from Voice Terminal ports used for Telephone Emulation.
Dial the next TE intercom number or the intercom number of the phone requiring access, and repeat the
previous steps.
Upon completion of progmmming return the T/P switch on the Voice Terminal to the center position.
NOTE:
If vacant Tel.Co. ports are being used to dedicate access to voice mail, verify that all voice mail users have
access to the vacant lines on their phones by following the previous procedures in steps 2 and 3.
Classic Mail Installation Package - Page 15
Merlin 206, 410 & 820 with Feature Module 2