Sony MAV-555SS Operation Manual page 32

DTR + DTR Mode (SD mode only)
Sync Generator
Video Camera
3-6 (E)
3-1 MAV-555SS Modes
This mode allows two cameras to be used for a live relay, with replay and slow-
motion playback during recording.
METER
PANEL
REF.
525
SYSTEM
PHONES
0
REF.
SDI/Composite
MAV-555SS
REF.
Configuration example
In this mode, the two groups of ports R1/P1 and R2/P2 are controlled from two
DTR-3000 units.
Use the basic menu item LIVE DURATION (menu 034) to set the recording time
for ports R1 and R2.
For details on basic menu settings and operation sequences, refer to Section 3-4, "Setup" (page
3-18).
Notes
• When a DTR-3000 is used with this unit, it must be version CP:V01.30,
VS:V01.20 or later, and this unit must be used in the DISK:INDIVIDUAL
mode. For details, please contact the supplier of the unit or your Sony
representative.
• To change from another operation mode to this mode, execute the -ALL
ERASE (menu 099) basic menu item and then reboot.
• When the LIVE DURATION time value is changed, or when recording from
the beginning of the recording area, existing material must be erased. Delete the
"LIVE1" (and "LIVE2") material in the Panel mode and reboot to this mode,
or reboot after erasing all material using the -ALL ERASE (menu 099) basic
menu item.
• Material recorded in this mode will be erased when this mode is again selected
from the Panel mode.
Dynamic Motion Controller
RS-422
COMPOSITE SDI
R1 P1 VIDEO
INPUT REMOTE
CONTROL
PANEL PORT SELECT
PROCESS
R2/ CONTROL VIDEO
625 SETUP BANK P2
P3
1 2 3
AUDIO INPUT / MONITOR SELECT CHROMA
INPUT CH1 CH2 CH3 CH4
HDD REMOTE
SDI
SET UP/BLACK
MENU
HELP AES/EBU
MONITOR L
LOCAL CHROMA/PHASE
TOTAL / FULL / ANALOG
R
REMAIN FINE
CH1 CH2 CH3 CH4 VIDEO/MENU
TC/UB TC TYPE PRESET PRESET PRESET PRESET PRESET
10
MENU
SET
SETUP
CONTROL PANEL SELECT PANEL SELECT CHARACTER
REAR FRONT 1 2 3 NONE 80TH OFF ON
RS-422
DTR-3000
Monitor
monitor
SDI/Composite
Dynamic Motion Controller
DTR-3000