Sony MAV-555SS Operation Manual page 47

Item number Display indication
030 DTR CUE LIST CLEAR
B
034 LIVE DURATION
B SUB MENU
DTR-1 HOUR (0 ..
DTR-1 MIN ( 0 ..
DTR-2 HOUR (0 ..
DTR-2 MIN ( 0 ..
DTR-1 LOOP REC
DTR-2 LOOP REC
035 VIDEO COMP. RATE
042 PORT CONFIGURATION
Basic menu items (Continued)
Settings
Selects whether to delete the DTR-3000 cue list when files are unloaded.
enable : The cue list is deleted.
disable : The cue list is not deleted.
In the DTR + Panel or DTR + DTR mode, specify the length reserved for recording.
DTR-1 settings apply to the R1/P1 pair, and DTR-2 settings apply to the R2/P2 pair.
Notes:
This is affected by the VIDEO COMPRESSION RATE and HDD capacity.
1 .. 23) Confirm the available disk space (SysRemain page 2-3), and follow the
notes below on setting. Maximum recording times are shown in the
59 )
following table.
1
.. 23)
Input/output
59
)
signal
Audio
SS mode
SD mode
• After changing LIVE DURATION, the material must be erased. Delete
the material named "LIVE1" (and "LIVE2") in the Panel mode and reboot
with DTR+Panel (or DTR+DTR) mode, or reboot after deleting all
materials.
• In DTR+Panel mode, the time specified by this menu must not exceed
SysRemain.
• In DTR+DTR mode, the time specified for DTR-1 plus the time specified
for DTR-2 in this menu item must not exceed the SysRemain time minus 3
minutes.
• If an incorrect setting is specified, the warning message "DM1 File Open
Fail" or "DM2 File Open Fail" appears on the front panel after rebooting.
In this case, make the correct setting, then reboot the unit.
• To record from the beginning of the disk, recorded material must first be
erased. In the Panel mode, delete the material named "LIVE1" (and
"LIVE2") in and reboot to DTR+Panel (or DTR+DTR) mode, or reboot
after deleting all materials by executing -ALL ERASE (menu 099).
Specifies whether to record in a loop within the allocated space.
off : Record normally
on : Record in a loop. When recording reaches the end of the allocated space,
recording returns to the beginning of the space and continues.
This item sets the default value for the recording video rate. (Note that this value is
always used for ports that are used by the DTR in DTR-panel mode or DTR-DTR
mode.)
30M bps
40M bps
50M bps
Specifies port configurations for input and output.
1 in 1 out Super Slow
2 in 2 out
3 in 1 out
1 in 3 out
30 Mbps
16-bit 20-bit
6 h 20 min 5 h 20 min
19 h 20 min 16 h
:SS mode
:SD mode
40 Mbps 50 Mbps
20-bit 20-bit
4 h 50 min 3 h 40 min
14 h 40 min 11 h 20 min
3-21 (E)
3-4 Setup