Honda GP160H Manual page 78

dummyhead dummyhead
Apply grease to the two starter ratchets [1].
Install the two starter ratchets and the two return
springs [2] to the recoil starter reel as shown.
Apply grease to the inside of the ratchet guide [1].
Set the friction spring [2] and the ratchet guide to the
recoil starter reel in the direction as shown.
Apply locking agent (ThreeBond® 2430 or equivalent)
to the threads of the set screw [3].
Hold the ratchet guide and tighten the set screw to the
specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7.0 lbf·ft)
Turn the recoil starter reel [1] more than 2 turns
counterclockwise to preload the recoil starter spring. Be
sure to hold the recoil starter reel.
Pass the recoil starter rope through hole [1] of the recoil
starter case, the starter knob [2], and then tie the rope
as shown.
Check the recoil starter operation (page 9-6).
STARTING SYSTEM
[1]
[1]
[1]
[2]
15 – 25 mm
(0.6 – 1.0 in) [1]
[2]
[3]
[2]
9-5