Honda GP160H Manual page 60

dummyhead dummyhead
GOVERNOR ARM/CONTROL BASE
REMOVAL/INSTALLATION
Remove the following:
– Air cleaner (page 6-4)
– Fuel tank (page 6-3)
• After installation, adjust the following:
– Governor (page 7-5)
– Idle speed (page 3-6)
– Maximum speed (page 7-7)
GOVERNOR ROD/THROTTLE RETURN SPRING
REMOVAL/INSTALLATION:
Pull the carburetor to a point where the
groove [1] of the throttle arm lines up with the
governor rod [2], and then lift the governor
rod out of the hole of the throttle arm and
unhook the throttle return spring [3].
[3]
SCREW (5 x 16 mm)
(Except VX3 type)
CABLE HOLDER
(Except VX3 type)
REMOTE CABLE
(Commercially available)
(Except QX3/VX3 types)
BOLT (6 x 12 mm) (2)
CABLE RETURN SPRING
(Except VX3 type)
CONTROL BASE
(REMOTE TYPE)
(Except VX3 type)
CONTROL BASE
(FIXED THROTTLE OPERATION TYPE)
(VX3 type)
GOVERNOR SPRING
INSTALLATION:
Hook the governor spring to the appropriate hole
on the control lever/governor arm as shown.
[2]
[1]
SCREW (4 x 6 mm)
(Except QX3/VX3 types)
GOVERNOR SYSTEM
GOVERNOR
ARM BOLT
NUT (6 mm)
GP160H:
GOVERNOR
ARM
GP200H:
GOVERNOR
ARM
7-3