Honda GP160H Manual page 61

dummyhead dummyhead
GOVERNOR SYSTEM
CONTROL BASE
DISASSEMBLY/ASSEMBLY
REMOTE TYPE
Remove the control base (page 7-3).
LOCK NUT (6 mm)
INSTALLATION:
After installation the control base Assy.,
measure force at 10 mm (0.4 in) from
the tip of the control lever [1] by pulling.
Adjust by turning the lock nut [2] so that
the gauge shows 19.6 ± 4.9 N (2.0 ±
0.5 kgf) when the control lever starts to
move.
[2]
[1]
LEVER SPRING
INSTALLATION:
Note the installation
direction.
CONTROL LEVER SPACER
CONTROL BASE
(Control lever sliding surface)
7-4
10 mm
(0.4 in)
CONTROL LEVER WASHER
INSTALLATION:
Install the control lever washer by aligning the cutout of the control
lever washer with the claw of the control base.
CABLE RETURN SPRING
CIRCLIP
(Except QX3 type)
CLAW
WIRE HOLDER (Except QX3 type)
CONTROL LEVER
SCREW (5 x 25 mm)
CONTROL ADJUST SPRING