Remote Control - Sony RDR-HX510 Operating Instructions Manual

The recording mode indication is incorrect.
, When the recording or dubbing is less than three
minutes, the recording mode indication may be
displayed incorrectly. The actual recording itself
is correctly made in the selected recording mode.
, After playing titles recorded in SLP and SEP
mode, the recording mode indication may
change depending on the recorded programme.
The clock does not appear in the front panel
display.
, "Dimmer" in "Options" setup is set to "Power
Save" (page 94).
, The "Power Save" in "Options" setup was set to
"On," and the recorder is in standby (page 94).

Remote control

The remote does not function.
, Batteries are weak.
, The remote is too far from the recorder.
, The remote's manufacturer code returned to the
default setting when you replaced the batteries.
Reset the code (page 19).
, Turn on the recorder.
, The remote is not pointed at the remote sensor on
the recorder.
, Different command modes are set for the
recorder and remote. Set the same command
mode (page 21). The default command mode
setting for this recorder and the supplied remote
is DVD3.
, Set the TV/DVD switch to DVD (page 20).
Other Sony equipment responds to the remote.
, The same command mode is set for both the
equipment and recorder. Set a different
command mode for the recorder (page 21).
Others
The recorder does not operate properly.
, Restart the recorder. Press down
recorder for more than ten seconds until
"WELCOME" appears in the front panel display.
, When static electricity, etc., causes the recorder
to operate abnormally, turn off the recorder and
wait until the clock appears in the front panel
display. Then, unplug the recorder and after
leaving it off for a while, plug it in again.
Five numbers or letters are displayed in the
front panel display.
, The self-diagnosis function was activated (see
the table on page 102).
The disc tray does not open after you press Z
(open/close).
, It may take a few seconds for the disc tray to
open after you have recorded or edited a DVD.
This is because the recorder is adding disc data to
the disc.
The disc tray does not open and "TRAY
LOCKED" appears in the front panel display.
, Contact your Sony dealer or local authorized
Sony service facility.
"RECOVERY" appears in the front panel
display.
, The recorder's recovery function was activated
when the recorder was turned on because the
power was turned off or failed during recording.
Leave the recorder on until "RECOVERY"
disappears from the front panel display.
[
/1 on the
,continued 101