Sony RDR-HX510 Operating Instructions Manual page 56

Buttons
(fast reverse/fast forward)
(slow, freeze frame)
+ +
RW RW
HDD
+
- RW R
Video
DVD VCD
* Playback direction only
X (pause)
To resume normal playback, press H.
b
Notes
• To enjoy the TVS function, set "Digital Out" to "On"
and "Dolby Digital" to "D-PCM" and "MPEG" to
"PCM" in "Audio" setup.
• The volume may be reduced when surround effects are
set.
• When the playback signal does not contain a signal for
the rear speakers, the surround effects will be difficult
to hear.
In addition, the surround effects may also be difficult to
hear depending on the title being played and the
environment where the recorder is being used.
• When you select one of the surround modes, turn off
the surround settings of the connected TV or amplifier
(receiver).
• Make sure that your listening position is between and
at an equal distance from your speakers, and that the
speakers are located in similar surroundings.
• Angles and subtitles cannot be changed with titles
recorded on this recorder.
• When you use the DIGITAL OUT (COAXIAL) jack to
listen to MPEG audio signals and set "MPEG" to
"MPEG" in "Audio" setup, no sound will come from
your speakers if you select one of the TVS modes.
• 96 kHz PCM audio and DTS audio do not have
surround effects.
• The surround effects do not work while performing
playback quickly with sound.
56
Operations
Fast reverses/fast forwards the disc when pressed during playback.
Search speed changes as follows:
m3
When you press and hold the button, fast forward/fast reverse continues at the
selected speed until you release the button.
*1
When you press
can play quickly with sound ("x1.5" appears).
*2
m
3 and 3
Plays in slow motion when pressed for more than one second in pause mode.
Plays one frame at a time when pressed briefly in pause mode.
- RW
VR
-
R
*
Pauses playback.
fast reverse fast forward
m1 T t 1M
m2 T T t t 2M
*2
T T T t t t 3M
M
once during playback of a title recorded in the HDD, you
M
are only available for the HDD and DVDs.
Notes on playing DTS sound tracks on a CD
• When playing DTS-encoded CDs, excessive noise will
be heard from the analogue stereo jacks. To avoid
possible damage to the audio system, the consumer
should take proper precautions when the analogue
stereo jacks of the recorder are connected to an
amplification system. To enjoy DTS Digital
Surround™ playback, an external 5.1-channel decoder
system must be connected to the digital jack of the
recorder.
• Set the sound to "Stereo" using the
button when you play DTS sound tracks on a CD
(page 55).
Notes on playing DVDs with a DTS sound track
DTS audio signals are output only through the DIGITAL
OUT (COAXIAL or OPTICAL) jack.
When you play a DVD with DTS sound tracks, set
"DTS" to "On" in "Audio" setup (page 90).
*1
*2
(audio)