Sony RDR-HX510 Operating Instructions Manual page 88

16:9
4:3 Letter Box
4:3 Pan Scan
b
Note
Depending on the disc, "4:3 Letter Box" may be selected
automatically instead of "4:3 Pan Scan" or vice versa.
Pause Mode (HDD/DVDs only)
Selects the picture quality in pause mode.
Auto The picture, including subjects
that move dynamically, is output
with no jitter. Normally select this
position.
Frame The picture, including subjects
that do not move dynamically, is
output in high resolution.
Component Out
Selects whether or not to output video signals
from the COMPONENT VIDEO OUT jacks.
On
Outputs the component video
signals. Select this when you want
to view progressive signals.
Off Outputs no signals.
b
Notes
• When you set "Line1 Output" to "RGB," you cannot
set "Component Out" to "On."
• When you connect the recorder to a monitor or
projector via only the COMPONENT VIDEO OUT
jacks, do not select "Off." If you select "Off" in this
case, the picture may not appear.
88
Progressive Mode
DVD software can be divided into two types: film
based software and video based software. Video
based software is derived from TV, such as
dramas and sit-coms, and displays images at 30
frames/60 fields (25 frames/50 fields) per second.
Film based software is derived from film and
displays images at 24 frames per second. Some
DVD software contains both Video and Film.
In order for these images to appear natural on your
screen when output in PROGRESSIVE mode (50
or 60 frames per second), the progressive video
signal needs to be converted to match the type of
DVD software that you are watching.
You can fine-tune the progressive 525p/625p
video signal that is output when you press
PROGRESSIVE ("PROGRESSIVE" lights up).
Note that you must connect to a progressive
format TV using the COMPONENT VIDEO OUT
jacks (page 14).
Auto Automatically detects the software
type (Film-based or Video-based)
and selects the appropriate
conversion mode. Normally select
this position.
Video Fixes the conversion mode to the
mode for Video-based software.
Scart Setting
Sets the method of inputting/outputting signals
from the SCART jacks on the rear panel of the
recorder. Select an option for each of the items
below according to the combination of jacks and
methods that you are going to use.
Line1 Output
Selects a method of outputting video signals for
the LINE 1 – TV jack.
RGB
Outputs RGB signals.
Video Outputs video signals.
S Video Outputs S-video signals.
b
Notes
• If your TV does not accept S-video or RGB signals, no
picture appears on the TV screen even if you select "S
Video" or "RGB." See the instructions supplied with
your TV.
• You cannot select "RGB" when "Component Out"
above is set to "On."
• SMARTLINK is available only when "Video" is
selected.